Bmarler's latest activity

Raptor deck was mentioned previously, I use a similar product in mine. It’s soft under foot and doesn’t seem to heat up too much in the...

Also, that thing you’re doing with the battery switch?stop it. Totally defeating the purpose of the isolator. The switch should be used...

I use link belts on certain equipment applications. It’s very good stuff, runs very smooth. I would have no problem running my...

100% of my manual steering is done with the autopilot remote follow up lever. If the rest was done through a mfd I wouldn’t have a issue...

I’d second that guess. There’s a gauge that has a red zone at the upper end of the range. That should be black or grey water.

Ok, good luck with it. Hopefully it’ll last as long as you need it to. But, as far as building a jig goes, it’s not that tough. I’ve...

You might attach a limiter to the scupper to keep it from opening more than 45 or 50 degrees. Either a lanyard from the bottom or a...

I know bronze is preferred for this application, but couldn’t you fab up a 316 stainless replacement?

You can use exhaust sealer if you want, I haven’t had any trouble just clamping the exhaust tubing directly to the fittings. Clamp...

The dosing pump shouldn’t have any problem pulling through the racor. I’d ditch the other filter. Those little pumps push better than...

I don’t worry so much about the air intake. I use the espar silencer, Espar / Eberspacher Airtronic Combustion Air Intake Silencer Clamp...

What the heck happened? It was listed in 2023 and looked decent. Was there some unseen issue? That’s a classic northwest fishing boat...

Have you checked the voltage of the batteries? A lot of inverters won’t function if the batteries are dead. You may need to bring in a...

That’s not too tough to repair. I’d try to get it out in big enough pieces so you can use them for a template. It’s probably just 1/4...

I’ll pass that on to him, thanks!