Search results

What size generator?

I replaced it. The rotor face was worn and the black ( i think its graphite) looked warn almost to the water nipple. They changed out the cutlass, everything went smooth, the boats in great condition around the strut and rudder. They found a good amount of blisters and ground them out, should be...

175 v 500

Preparing to haul out to replace the cutlass bearing and paint the bottom. The PSS shaft seal has 6500 hours since installed new. Can it be saved with a maintenance kit or should I buy new one?

I got into a fixer upper. It was worth it to me. Needed cosmetics and electronics. I have also converted it over to do more fishing. My only suggestion is find a boat with good bones. For me it was the following - Motor / 3208N - Generator / Northern Lights - fiberglass tanks that drain from the...

Keep us updated, I am interested in your results. Thanks

I have a 1999 5kw NL with 4500 hrs. Mine smokes a little when I am pushing her, 24 amps consistantly, two 16000btu a/c's running. She runs for a few days in a row, I shut her down every 8 hrs to check the oil and make sure everything is fine. How much smoke are we talking?

3208N in So FL and Bahamas - 187 never changes.

This is great info, Thanks

Please keep updating!! How did it work crossing the bank?

You've got my interest, please follow up in a few days..

My go to list in the Bahamas: Southern Abaco - Petes Pub Spanish Wells - Sandbar and Ship Wreck Eleuthera - French Leave Exumas - Staniel Cay Yacht Club

I have a 42 Bruno & Stillman, 1 1/2 ft chop, 15 knots of wind on the bahama bank and I can not feel it. Bow has face the weather or you will rock around. I do have an aft cabin, that helps a lot.

Keys route 100% and then cut across. The current alone will make you happy!!

I do not know off the top of my head, sorry

I was just informed of a wedding I have to attend in February. I am hoping it does not fall on the same dates, I have been looking forward to taking my boat up..

Are there any 2022 plans??

Purchased a Sherwood Pump P176X from: Trans Pacific Distributors a year ago for my 3208N, cheapest I could find on the net and delivered on time.

That's what I was thinking. Thanks

LOL ok thanks and thanks and thanks. Port or out the stern for a bilge discharge? I want to put it on the stern out of convenience but never actually observed one or owned a boat with a stern discharge..

They run together always have without issue. Prior setup ran them to a thru-hull under the boat. I have decided to use the underwater thru-hull for a new 16k A/C. As you know we need two 16k units to be comfortable down here..

Aft bilge and a large deck hatch drain with two 1 inch drains.

I am adding a new thru-hull above water line and want to know if I can install it next to my exhaust or should I install it on the port side? It will be at least 10 inches above the waterline either way.

House batteries only run the inverter. The boat is a 42 Bruno Stillman, all electrical updated in 2002. I have some investigating to do on this in an hour or so..

I have house batteries (4-6volt to make 12v), a single D8 to start motor and another battery for the generator. While sleeping over night with the lights and fan on it runs the battery down, I had to jump it this morning. I also found that my alternator is not working either..(currently have...