Search results

Holly tree

Was the trans part of the mounting system of the engine, or engine support on the block w trans hanging on ? If trans not part of mounting it should be darn close on replacement.

To make it easier on your machine, first buy one I have for sale ! Seriously, if you are using a large spool of thread, douche it real well with silicone. Helps go thru material & lines the needle a bit too.

Don't know manatee. But on last big boat, lifting engine rm floor revealed LOTS of free space. Or, bolt flat against inside transom

Try a pre-flush application of a tool. A machete comes to mind...

Coincidence, I just tried JB on marelon. Seems to hold.

Marine salvage connection Ft Pierce

Arch is up for fitting. Final placement prob 16" further back. Note this will be mounted to the inside of the bridge, decision made thru the lens of availability and price ($300).

..... .and don't go to Baltimore.

NICE boat ! 4's or 6's ?

Ah, give her a break.

I have seen pockets of uncured resin appear, but mostly when removing hull blisters.

I see they are female. I've been looking for female sex nuts for all my life

If you are tired of patching it, I can make you one & ship it for $350 from your old one. You would have to put snaps in. Id send you the snaps and tell you how to fit it on. Pm if interested pls.

If I didn't have your collective input, I'd try smooth even pressure. Make a "slug" same diameter as pipe, with hefty chain thru the tube. On the outside , a "bridge" spanning over area from transom to lower keel. Threaded rod or puller to chain & start cranking on the nut. As it (hopefully)...

Well, this is a cosmetic repair, not a restoration. My inclination is to shoot a bunch of glue into the separation and run screws up into the structure above and see if it sticks. Good thought on checking if is FG sandwich. Whatever I do, I ll adds drip-lip to it.

So I'm finally finishing the electrical and ready to start exterior projects. See the pic. The underside of the bridge is seriously separated. I want to do a repair, but with an eye towards the age of Phelps & me, not get nuts. What would you Guru's do ?

Nice boat. Where in MD are you ?

For bending 1" SS I use an appropriate bicycle wheel. You must pad the wheel well or the spoke ends will print into the SS. One BIG tip - be sure the weld seam is not at the "side" of the bend. It could flatten at that spot. Inside the curve is best

I have done both glued monkey fur and pulled fabric. What is yours?

And I'd use SS. Speaking of SS, I discovered Tractor Supply has lots of bolts etc SS and plain- less than HALF the price at Homers and better selection.

Scuse my partial hijack here- I need a charger & there is one exactly like this for sale local. Apparently Charles is out of business ? Should I jump on it for $150 ?

West Systems can almost restore human life

Nice! Don't spose you want a mast ?

Don't know about use ability, but there's a million 4BTs around for parts.