Anode
Guru
I did a quick 'search' and couldn't find anything on the topic so I'll ask the question.
I have the fuel tanks out of Scout and am getting ready to coat them with coal tar epoxy before re-installing. The coal tar epoxy is my choice at the moment but I've been reading about Gluvit and the idea of fiberglassing over.
Tanks are aluminum,*5 years old (installed by PO when the re power was done)*and in great shape. They were painted when new (paint unknown) but it's starting to flake off in a few areas.
Any thoughts on this?
Also looking for something to 'bed' the tanks with where they sit on the fiberglass shelf. I think there was some kind of rubber strips under them when I removed them but it had deteriorated in 5 years.
Thanks
Chip
I have the fuel tanks out of Scout and am getting ready to coat them with coal tar epoxy before re-installing. The coal tar epoxy is my choice at the moment but I've been reading about Gluvit and the idea of fiberglassing over.
Tanks are aluminum,*5 years old (installed by PO when the re power was done)*and in great shape. They were painted when new (paint unknown) but it's starting to flake off in a few areas.
Any thoughts on this?
Also looking for something to 'bed' the tanks with where they sit on the fiberglass shelf. I think there was some kind of rubber strips under them when I removed them but it had deteriorated in 5 years.
Thanks
Chip