Search results

Look at Intersleek 1100SR. It may be updated by now under a different name. My diver says it's the best bottom paint he's ever seen. Yes, a barnacle will stick to it, but he says you can flick it off with your finger and no husk is left behind without scrubbing (unlike most other bottom...

Laird or onlinemetals.com also carries starboard in black and white, smooth or textured, will cut to dimension.

Looks great. The WR-LPU is being replaced by something called "Pennant." Not sure if it's actually a reformulation or just branding. Have you used the water based epoxy primer? Which Graco gun are you using? There's a couple different levels of guns with more or less control over pressure.

Thanks. Single or twins? We were towing a heavy dinghy so we are probably in about the same ballpark. What kind of fuel economy do you get?

Update on my project I finally pulled the head and went after my piston slap problem. Both #1 and #2 were pretty well knackered with aluminum stuck to the tops of the cylinder walls. #1 had two compression rings frozen in their grooves, #2 had one frozen. I used a ridge reamer, not to ream...

Looks like May 4-6 Kingston, WA

Hi Airstream. I did pick up an $18 scope from amazon, they're down to 5.5mm now which should fit in the injector hole. Will be the first task I guess. Wow, thanks for the BW40 info! Ours "Ceres" is an aft cabin on the same hull, so quite a bit different than the Portuguese bridge versions...

Slight hi-jack of the thread with a similar issue. I picked up a 40' Bluewater Trawler in December for next to nothing. Motor runs, but not being very tuned into the noises of the Lehman 120 I didn't notice "the knock." I did replace all the heat exchangers, oil lines, updated raw water pump...