Search results

My upper helm capilano system has a vent hole.

Oh ok awesome

Rolex?

I will keep that in mind.

I have 300 ft of 3/8" chain looking to put on 400 ft. Just called today to get some prices on chain. Should here back tomorrow.

Its make is a north sea ( marine trader)

Well i want to give my engine room a fresh voat of paint. I ran out of paint but getting more. Also found out they discontinued the paint color and apparently i got the last on. They need to ship it from Ontario. So will continue paintung next week some time.

I will give it a few trial runs and if it comes up as it should i will not put a swivel on. I guess im just use to having one on my old anchor

I would like to add a swivel but i dont have enough room between the end of the shank and the gypsy

It replaced a home made stainless steel anchor plow type.

Nice i have 300ft of chain. Thanks for the info.

Yes i certainly will post on how it performs.

The flag will stay. Sorry but being a retired submariner, the flag must fly.

Yes, i got it from Vancouver. I hope they hold up to all the hype. But the fit is good on my bow. I would like a few inches smaller to able to but a swivel on it. Right now it just has enoigj room for a shackle.

Neat idea

Good Day folks, During the last wind storm we had here on Vancouver Island, the pressure from the bimini enslosure cracked my windscreen. It was made out of tinted plexiglass. I only have two support brackets that suppport the windscreen, leaving the center section not supported. So here is my...

I used these on our sliding doors. Workg good so far. They are not stainless though.

I do agree with you for sure. Im not going to tear the bilge up to solve it. I will let whatever flow out and get rid of some of the water. Then epoxy over it when it stops at some point. Sent from my SM-G930W8 using Trawler Forum mobile app

Oh ok Sent from my SM-G930W8 using Trawler Forum mobile app

Where did you install the drain plug. Sent from my SM-G930W8 using Trawler Forum mobile app

Yes i may do that from now on.

We just did a full bottom paint and seen no signs of damage that would allow water in. Inless its coming in from the cutlass bearing area.

I am hoping that is it. Next year when im on the hard i will cut it open and investigate further. For now i will make sure my bilge pump is in good working order.