Search results

The friendliest place on the web for anyone who enjoys boating.
If you have answers, please help by responding to the unanswered posts.
  1. ismar1

    Help explain coolant expansion tank??

    Have same engines with set-up as JSK55 mentions . Thankfully no issues till now after 1600 hrs and trips of 800nm.:)
  2. ismar1

    Lets talk about being STUPID again

    On my previous boat, it had both a fuel gauge and a glass sighting tube. Back than the new to me boat was reading 3/4 to 1/2 full fuel approx. After using the boat a couple of times the reading on the gauge started getting below 1/4, after 2 more short trips it was on reserve. Decided to check...
  3. ismar1

    Name the one thing you dislike about your boat

    On my boat there is only side access on the port side, better if there was on S board as well. Wish I had electrical and water connection at the bow as well. Hope to have done in future.
  4. ismar1

    Dripless shaft seal flow meter. Good or bad idea?

    Unfortunately no I have not seen any other Belliures. A while ago I had another boat with a similar shaft seal but in this one, instead of the small pipe being connected to the engine intake, it was connected to an underwater through hull seacock. Boat cruised at 22knt, had it for 10y with no...
  5. ismar1

    Dripless shaft seal flow meter. Good or bad idea?

    Yes that is the situation. Reason why I asked for your views as at times it worries me. However at higher rpm the sea water pump would be sucking up larger amounts of water. The seal is PSS and boat cruises at 15 and max 19 knt. At times I`ve checked by hand at various speeds warm but never...
  6. ismar1

    Dripless shaft seal flow meter. Good or bad idea?

    Yes it is connected to the intake side and before the sea water pump. There is a T connection under the water filter to which a small 1/2 inch pipe is connected to the shaft seal. So when engine is running it draws water from the main water pick up and from the shaft seal through the small pipe.
  7. ismar1

    Dripless shaft seal flow meter. Good or bad idea?

    Hello, I notice that most shaft seals are connected to the exit end of the cooling sea water circuit. on my boat the water feed to the shaft seals is connected to the water intake end . Any thoughts whether this functions just as good or not ? Up to now I never had any issues but than I`ve only...
  8. ismar1

    Does anyone know the mechanism of a Flexible drive coupler?

    Could be or looks similar to a Vetus shaft coupler. To my knowledge these couplers are installed as a vibration absorbers and as the weak link in the transmition in order to save the gearbox, I don`t believe they allow any slipage
  9. ismar1

    Hello from Malta

    Recently talks were held with the Royal Family to have the house restored
  10. ismar1

    Hello from Malta

    Hello again Thank you all for your warm welcome, already feel like I am one of you. Malta is a tiny island in the middle of the Med sea, just 50 miles south of Sicily. Yes I do believe we still have one of the war planes in the museum, remember seeing it back in my school days when as students...
  11. ismar1

    Hello from Malta

    Hello to everyone, have been following this forum for quite a while. Registered about 2 months ago. Thought I make my first post as intro. Never been a member in any forums before so might do some mistakes in my posts, for which I apologize beforehand. Very interesting topics especially...
Back
Top Bottom