Mrwesson
Senior Member
My thermostat has been removed and while not extremely difficult it's not at all convient to access/remove the thermostat housing.
Engine is running at around 120 degrees and very smoky(Bad).
I was thinking of adding one of these but unsure at what point in the lines I should add it.
This would allow me to easily access the thermostat in the future without removing 12 bolts and then some. Another bonus would be I could pinch/cap the lines so I don't have to drain all the coolant beforehand.
Where would you put it on a Perkins 354 160hp(turbo)?
Engine is running at around 120 degrees and very smoky(Bad).
I was thinking of adding one of these but unsure at what point in the lines I should add it.
![21vRCx9IH1L.jpg](/proxy.php?image=https%3A%2F%2Fimages-na.ssl-images-amazon.com%2Fimages%2FI%2F21vRCx9IH1L.jpg&hash=5726b0cfaa03b1d5807f4c4db934e84f)
This would allow me to easily access the thermostat in the future without removing 12 bolts and then some. Another bonus would be I could pinch/cap the lines so I don't have to drain all the coolant beforehand.
Where would you put it on a Perkins 354 160hp(turbo)?