Hello. Looking for some advice on adjusting our stabilizers.
Our trawler is fitted with a NAIAD MultiSea II Stabilizer Control System. Overall, the system works as intended. However, they seem to be directionally out of adjustment. When centered (button pressed on the control panel), the port and starbaord fin indicators are right in the middle as expected, and the hydraulic pistons on the fins are also where they should be.
However, when I press "active," even in completely calm conditions, the port fin indicator goes up (fin out), while the starboard one goes down (fin in), and the boat pulls to port. They stabilize as they should, but are always biased with port up, starboard down.
I'm looking for a manual or procedure to adjust this. What I have been able to find online doesn't address this condition. Any help is greatly appreciated.
Kind regards,
Casey Corcoran
Our trawler is fitted with a NAIAD MultiSea II Stabilizer Control System. Overall, the system works as intended. However, they seem to be directionally out of adjustment. When centered (button pressed on the control panel), the port and starbaord fin indicators are right in the middle as expected, and the hydraulic pistons on the fins are also where they should be.
However, when I press "active," even in completely calm conditions, the port fin indicator goes up (fin out), while the starboard one goes down (fin in), and the boat pulls to port. They stabilize as they should, but are always biased with port up, starboard down.
I'm looking for a manual or procedure to adjust this. What I have been able to find online doesn't address this condition. Any help is greatly appreciated.
Kind regards,
Casey Corcoran
