Chris Foster
Senior Member
Hi -
My Rawson has three fuel tanks - two 150 gallon aft, and one*75 gallon forward - all aluminum.* The boat is pretty light aft, as the hull was originally designed for a commercial fishing boat with lots of equipment, etc mounted aft.
So I'd like to keep the forward tank empty, but leave it in a state that I could use it in the future if I need it (an Alaska trip, for example).
My plan is to drain it down as much as I can.* Then I'll disconnect the vent from the overboard fitting and route it to a small in-line dehydrator , ultimately venting to the engine space.* This should keep any additional moisture from entering the tank during temperature changes.
The tank doesn't currently have inspection ports, but I'll add those prior to using the tank again in order to clean out whatever's left in the bottom.
Any other thoughts about what I should do?
My Rawson has three fuel tanks - two 150 gallon aft, and one*75 gallon forward - all aluminum.* The boat is pretty light aft, as the hull was originally designed for a commercial fishing boat with lots of equipment, etc mounted aft.
So I'd like to keep the forward tank empty, but leave it in a state that I could use it in the future if I need it (an Alaska trip, for example).
My plan is to drain it down as much as I can.* Then I'll disconnect the vent from the overboard fitting and route it to a small in-line dehydrator , ultimately venting to the engine space.* This should keep any additional moisture from entering the tank during temperature changes.
The tank doesn't currently have inspection ports, but I'll add those prior to using the tank again in order to clean out whatever's left in the bottom.
Any other thoughts about what I should do?