Separation of VHF Antennae

[JDCAVE]

Ok ok, you say "antennas" and I say "antennae". It's the biologist in me. Insects have two "antennae".

So I have currently have a Shakespeare VHF antenna on an extender pole, I believe it goes up 16'. I would like to mount a second antenna, a Shakespeare 5225XT, about 14-16" away on the flybridge combing. This link here suggests verticals separation achieves more than horizontal separation, so I may be ok.

How close can I mount two VHF/UHF antennas | KB9VBR J-Pole Antennas

Any thoughts on this issue?


Jim
Sent from my iPad using Trawler Forum

 

[Paul Swanson]

The information in the link is correct. The radiation pattern of a vertical dipole antenna (like yours) is primarily in a plane perpendicular to the antenna axis, that is, parallel to the water. Not much radiation goes directly up or down. Therefore another antenna above or below will have minimal interaction. However, the 16' pole supporting the first antenna can interact with the second antenna if it is metal. If it is fiberglass there should be no problem.

Paul

 

[JDCAVE]

Thanks Paul the support "pole" is fiberglass, and is made by Shakespeare. Just how thick is that "doughnut"? Is it the entire length, or situated more near the top?

Jim
Sent from my iPad using Trawler Forum

 

[markpierce]

Don't know. Regardless, my single VHF antennae works.

 

[denverd0n]

The "doughnut" is pretty thick, and the signal radiates from the entire antenna. It extends above and below the antenna, also. As such, you still want some vertical separation, if you can get it. Wikipedia has a pretty good explanation of dipole antennas, including a diagram of the radiation pattern... https://en.wikipedia.org/wiki/Dipole_antenna