Capt. Rodbone
Senior Member
- Joined
- Sep 6, 2020
- Messages
- 177
- Location
- U.S.
- Vessel Name
- SV Stella Polaris MV Sea Turtle
- Vessel Make
- 1978 VanDine Gaff rigged schooner, 1978 Grand Banks Classic Trawler
With the exception of the few repairs i’m asking for suggestions on here, I’m about ready to begin varnishing our Grand Banks 42 transom after having wooded down.
1. She’s new to us as of October. No idea what. it was at one point fastened with the holes you will see in one photo below, but I’m looking for any advice on what to fill these with to get the closest color match possible. There are small holes so even a less than perfect pigment filler could be dabbed with some stain or furniture repair marker before varnishing and hide these pretty well, but I’m wondering if any of you have tricks that have worked for you?
2. Also looking for suggestions regarding the pic that shows a little bit of missing wood and the gap between the teak molding and the fiberglass transom. My thoughts are to mix some epoxy and some teak dust I have kept and fill this gap than fair and put a bead of sealant. Is that the best plan or do you have other ideas. It’s neither long enough nor bad enough in my opinion to go to the trouble of scarfing in a piece of teak.
3. The other picture shows a couple of small cracks and the actual planks themselves. These are so small I plan to put unthickened epoxy in them for sit in some white, then cover with tape to keep it from draining out.
4. Finally and you can see a bit of it in the pic of the small crack(photo attached vertically instead of correctly horizontal)when I cleaned the gap between the boards further it shows a little better the small gaps at some spots between the planks. I want to run a very thin bead of the proper sealant in those spots however I’m wondering what would be both a weather resistant seal that also didn’t stand out when I start applying varnish.
Thanks in advance to any of you veterans of these projects for your thoughts and suggestions!
1. She’s new to us as of October. No idea what. it was at one point fastened with the holes you will see in one photo below, but I’m looking for any advice on what to fill these with to get the closest color match possible. There are small holes so even a less than perfect pigment filler could be dabbed with some stain or furniture repair marker before varnishing and hide these pretty well, but I’m wondering if any of you have tricks that have worked for you?
2. Also looking for suggestions regarding the pic that shows a little bit of missing wood and the gap between the teak molding and the fiberglass transom. My thoughts are to mix some epoxy and some teak dust I have kept and fill this gap than fair and put a bead of sealant. Is that the best plan or do you have other ideas. It’s neither long enough nor bad enough in my opinion to go to the trouble of scarfing in a piece of teak.
3. The other picture shows a couple of small cracks and the actual planks themselves. These are so small I plan to put unthickened epoxy in them for sit in some white, then cover with tape to keep it from draining out.
4. Finally and you can see a bit of it in the pic of the small crack(photo attached vertically instead of correctly horizontal)when I cleaned the gap between the boards further it shows a little better the small gaps at some spots between the planks. I want to run a very thin bead of the proper sealant in those spots however I’m wondering what would be both a weather resistant seal that also didn’t stand out when I start applying varnish.
Thanks in advance to any of you veterans of these projects for your thoughts and suggestions!