Recent content by PNM

Thanks for your inputs. Letting it age won't stop the leaks at the seams and fasteners. I will have to take it apart and reseal all of the joints to take that approach. I used Interlux Zinc Chromate when I did the top 10 years ago.

Thanks for your comments. It is just time for the top to be recoated. I did and Interlux coating 10 years ago and it is pretty much shot. I am putting a vinyl beadboard header in the aluminum dog house cover and found a few spots where water was seeping through the cover (seams, screws, pop...

Title tells the story. I am about to coat the sheet aluminum top to my fully enclosed upper helm with a 100% silicon roof coating. Am I crazy? I will add play sand to provide a less slick surface to walk on when it is raining should I have to go up top. I have considered an acrylic coating...

Good point.

Thanks for the re-assurance. My diesel mechanic did not seem too concerned about the small part, likely residing in the oil sump, though he stated it was not a "good" thing. So, I did not panic when I discovered the missing part. I am going to completely clean that engine and associated bilge...

After 8 years on the "hard", with little TLC, and 3 years in the water - never leaving the dock, having received many valuable suggestions from the many knowledgeable members of this forum over the last three years and the help of Brian, from Shipwright Harbor, Deale, MD, I just moved my 45 year...

FYI! I found a used replacement "L" and it has a metal extrusion with a plug in it extending from where I have a hole. I don't need to attach anything to my exhaust output, so, I just drilled and tapped at 5/8" and put a plug in it. Then I sealed the "v" clamp joint with high temp exhaust gasket...

Thanks for your input. The end of the dipstick is about 3/4" long x 1/4" wide x 1/16" thick. I think there is a screen on the oil pick-up line in the oil sump. I would hope that would catch the metal. Wouldn't the oil pump be after the oil filter? My filter is up-side down, so it drains back...

My upper helm and aft doghouse cover is fabricated of welded square aluminum tubing with pop riveted aluminum sheeting, covering the frame. It is strong and can be walked upon without issue. While installing insulation enclosed by pvc bead board to the underside of the aft doghouse cover, I...

Thanks for all of the expertise and suggestions evident in the responses. I read an interesting blog from a Combiner Company Site. KISS was the primary message. I'm thinking - use my current switching arrangement to combine the two start batteries by keeping the switches in the both position...

I have two engine alternators, two start batteries and one house battery. The start batteries are isolated/combined/controlled by two battery switches and can be attached to Port, Starboard, or Both engines. The House battery is isolated, with no cabling connected to the start batteries. I want...

On a recent move to a new marina, I noted that one of my two engine alternators was not working. To keep both start batteries + the house battery charged, I combined the two start batteries using the battery switches - set to both - and the house battery with a jumper cable. My Port alternator...

Anybody know where I can buy one? Mine is broken off just below the max full line. If you don't I will get a piece of steel welded on to match my other engines dip stick. Thanks

Why change fuel filters each year??? Before the season starts, I run my set of Racor 1000's (with 2 micron filters) polishing system a few hours on each fuel tank to get any "gunk" or water out, then all fuel goes through the Racor 1000s before it gets to the on-engine filters. I pulled the...

Fuel filter gasket installation difficulties Thanks. I will try that.