Search results

Preparing to haul out to replace the cutlass bearing and paint the bottom. The PSS shaft seal has 6500 hours since installed new. Can it be saved with a maintenance kit or should I buy new one?

Are there any 2022 plans??

I am adding a new thru-hull above water line and want to know if I can install it next to my exhaust or should I install it on the port side? It will be at least 10 inches above the waterline either way.

Seems to happen when i am in any bit of a sea. 3 foot sea and it stops working. Any suggestions?? Sending this message while underway...

I have blasted fresh water into the intake hose, then attached it to the raw water source and it will prime. It runs for an hour and I shut it off thinking we are good to go. The next day I go out, gen runs all day and when we stop for the evening it looses prime and shuts down. I have scraped...

So new to me motor was running warm. I had a mechanic come out and he looked the motor over, ran it up to temp and used a IR gun to get a accurate temp. He says "change your gauges and sensor". Talked to two other mechanics and they said, open up the heat exchanger.. Well here is where we are...

I am going though a new to me 42 Bruno Stillman and have an issue with the toilet. It is a jabsco quiet flush freshwater toilet and there is a crack in the base drain. Replacement is around $550 for the Jabsco. I wouldnt mind replacing the base only, figuring out the correct base is becoming a...