timjet
Guru
- Joined
- Apr 9, 2009
- Messages
- 1,920
I've finally got my boat in a regular marina and am able to get full power, 2 30 amp connections. My air cond unit has a humidity mode whose purpose is to reduce the humidity by cycling the compressor on and off at reduced levels while the boat is unattended. I left the boat today with the ac system in the humidity mode, but on the drive home I began wondering if this is a good idea.
The air cond water pump probably pumps several gallons a minute, far more than my 3 dc powered bilge pumps can pump combined. My system is setup with one water pump servicing 2 ac units. If a pump tube were to leak or a connection were to come apart, the pump would continue pumping sea water into the boat. If a connection were to break near one of the units, that unit would overheat and shutdown, but since the pump services two units, the other unit would still command the pump to operate.
A couple of thoughts:
A high water bilge alarm connected to a cell phone notification system might work to alert one to the problem. But unless you get to the boat and stop the pump within an hour or two, it may be too late.
Circuitery that would shut down the pump if one ac unit overheats. The problem I have with this is all the ac plumbing on my boat is below the water line, so I would still have water intrusion at the break or broken connection.
I'm headed back down to the boat this weekend and will problably leave the air cond off with the thru hull valve closed unless you guys have better advice.
The air cond water pump probably pumps several gallons a minute, far more than my 3 dc powered bilge pumps can pump combined. My system is setup with one water pump servicing 2 ac units. If a pump tube were to leak or a connection were to come apart, the pump would continue pumping sea water into the boat. If a connection were to break near one of the units, that unit would overheat and shutdown, but since the pump services two units, the other unit would still command the pump to operate.
A couple of thoughts:
A high water bilge alarm connected to a cell phone notification system might work to alert one to the problem. But unless you get to the boat and stop the pump within an hour or two, it may be too late.
Circuitery that would shut down the pump if one ac unit overheats. The problem I have with this is all the ac plumbing on my boat is below the water line, so I would still have water intrusion at the break or broken connection.
I'm headed back down to the boat this weekend and will problably leave the air cond off with the thru hull valve closed unless you guys have better advice.