JohnP
Guru
- Joined
- Dec 13, 2009
- Messages
- 1,362
- Location
- USA
- Vessel Name
- V E N T U R E
- Vessel Make
- 1996 36' Island Gypsy Classic
I have no space for a shaft zinc on my boat (besides the two on my rudder post).
I do have a anode on the end of the shaft=acorn shaped that has a center hex bolt.
As the zinc dissolves I noticed the hex bolt needs retightening. Is that normal or am I waiting to long to change it?
During my Winter in water layup I hang a large zinc overboard wired to the rudder post, prop shaft and bonding system.
If I installed a zinc block on the transom could I do away with prop zinc set up?
Just planning haul out- to do list.
JohnP
I do have a anode on the end of the shaft=acorn shaped that has a center hex bolt.
As the zinc dissolves I noticed the hex bolt needs retightening. Is that normal or am I waiting to long to change it?
During my Winter in water layup I hang a large zinc overboard wired to the rudder post, prop shaft and bonding system.
If I installed a zinc block on the transom could I do away with prop zinc set up?
Just planning haul out- to do list.
JohnP