Montenido
Senior Member
- Joined
- Dec 3, 2014
- Messages
- 386
- Location
- Mexico
- Vessel Name
- Ansedonia
- Vessel Make
- Californian/Carver 52CPMY
Hi folks,
My boat has two 5" diameter FRP 2-into-1 wyes that are for the wet exhaust on each engine (Cat 3208 NA). One of them has a small crack that drips saltwater. Can I repair this with epoxy, or should I use some type of high temperature resin? I think that I can do it from the inside of the wye, and then finish it on the outside. Has anybody done a repair like this?
Thanks for any tips.
Cheers, Bill
My boat has two 5" diameter FRP 2-into-1 wyes that are for the wet exhaust on each engine (Cat 3208 NA). One of them has a small crack that drips saltwater. Can I repair this with epoxy, or should I use some type of high temperature resin? I think that I can do it from the inside of the wye, and then finish it on the outside. Has anybody done a repair like this?
Thanks for any tips.
Cheers, Bill