Search results

I reached out to Yanmar directly and yes there is only one zinc on the heat exchanger. Thanks for all the info !!!!!

David - this is very helpful. I really appreciate your info. Thank you !!

Thank you for the info. The engine manual does not give the location and number of zincs - just when to change them !

That’s is very helpful. Thank you.

Thank you David My engine is a 2010 and I had one Yanmar mechanic insist there’s only 1 on the whole rig located on the main heat exchanger. Thank you for the info !!!

Thank you David. What year is your engine please ?

Can anyone please confirm that this model Yanmar has only one zinc on the entire engine? Manuals are unclear. Thank You,

I need to access a control on the helm. Does the helm lift up to access the electronics? I have tried to raise it but it won’t budge. Can not locate fasteners or latches. Lift back to front looks like the most feasible ? Thank you for the help.

Porman - Thank you for the info. Mine is a bit different with a bracket underneath and four plastic round nuts. I can reach only the front two from the main switch panel. Thank s for the suggestion! Cheers

The clearances of the frontwire harnesses is minimal so i think it may tilt up from the rear. That will be my next move. Thanks to all for weighing in.

That makes sense. The garmin and yanmar units must be accessible. I tried to wedge my hand under through the main control panel - no luck. I think i may have to remove some upholstery to access fasteners. Just can not locate any. Thank you.

I cannot figure out how it lifts I assume the front tilts up but it’s held in place. Do you recall where the release is ? Thank you.

2010 Mainship 395 - I need to replace thruster control pad. It’s inaccessible from main switch panel. Does the helm panel lift up to provide access ? How do you access the other electronics on the dashboard. Help ��*♂️ Thank you

Thank you all for the info. Yes these screw go into the transom but are not thru bolted.

Hello, I recently hauled out for bottom paint and found the swim platform support posts almost completely detached. The #12 screws had almost all sheared of at the screw head. see photos. I was wondering if anyone else has experienced this and what was the best fix? I do not like the idea od 12...

Thank you - I will look into that system.

Hello Friends, Has anyone purchased a boat monitoring system that informs you through text alerts or messaging of high water and other issues? What was your experience and advice ? Thank You !!!

Hello Forum, My question is about advice on my 2010 Mainship 395. I recently purchased a Highfield tender 9' and 20hp outboard. My Mainship has an existing Weaver Davit system but I am unsure of the best mount for the outboard. It is just heavy enough for two of us to lift it aboard. I am...