Moonzy1
Senior Member
Pulled my coolers this weekend and sent the cartridges out
Kept the housings to clean myself.
To remove the black very hard gunk that is left behind on the mating surfaces of the housing and end cap...is it ok to take an orbital sander w 220 grit to it to clean it up? w light pressure
Housing is Aluminum and caps are brass I think.
Ive tried every type of solvent and doesnt get it off.
Motors are yanmar 6LYA 370's
Thank you
Kept the housings to clean myself.
To remove the black very hard gunk that is left behind on the mating surfaces of the housing and end cap...is it ok to take an orbital sander w 220 grit to it to clean it up? w light pressure
Housing is Aluminum and caps are brass I think.
Ive tried every type of solvent and doesnt get it off.
Motors are yanmar 6LYA 370's
Thank you